Bonjour de Finlande,Comme je n'ai pas pu poster dans la section moteur R5 Alpine, je poste ici.Je suis sur le point de mettre un arbre à cames R5 Alpine Turbo dans un bloc standard (Twingo), qui a les alésages standard de 38 mm pour l'arbre à cames.
J'ai acheté la bague d'arbre à cames 1 (77.00.512.850) et avant d'essayer de l'installer,
je voudrais vérifier que cette bague doit s'adapter au trou de 38 mm dans le bloc ou est-ce que le trou de bague R5 Alpine / AT est de taille différente?Quelle est la taille du bloc R5 Alpine / AT où cette traversée s'installe?Désolé mon mauvais français, alors j'utilise Google Translator.
BR,
Jussi
***************
Hello from Finland,
As I was not able to post to R5 Alpine motor section, I post here.
I am about to put a R5 Alpine Turbo camshaft to a standard (Twingo) block, which has the standard 38mm bores for camshaft.
I have purchased the 1 camshaft bushing (77.00.512.850) and before I try to install it I would like to check that this bushing should fit the 38mm hole in the block or is the R5 Alpine / AT bushing hole different in size?
What is the size in the R5 Alpine / AT block where this bushing instals into?
Sorry my bad French, so I use google translator.
BR,
Jussi